The IS3500RT inverter-type voltage stabilizer provides high-quality power supply for a wide range of household, specialised and commercial electrical appliances in conditions of unstable mains voltage. The device is suitable for powering loads with a total active power of up to 2750 W.
The device is manufactured in Russia and is available in two versions, 220 and 230 V. It is designed for operation in Russian power grids. The quality of its operation is confirmed by a Customs Union certificate of conformity (EAC). The manufacturer provides a warranty on the device for 2 years.
The unit is equipped with a special stabilisation principle – double power conversion, which ensures an instantaneous response (0 ms) to any deviations in mains parameters with maximum accuracy (±2 %) across a wide input voltage range (90-310 V). It also has an output voltage with a perfect sine wave and the ability to provide uninterrupted power supply to connected devices in the event of a possible power outage (up to 200 ms).
The modern intelligent cooling system for the stabilizer's operating components is represented by two low-noise fans with adaptive speed.
Installation and connection
The stabilizer is installed using the mounting parts supplied in the kit – on the floor on support feet or in a rack using brackets in 19-inch rack or cabinet rails.
Terminal blocks are provided on the rear panel of the stabilizer for connection to the mains. The load can be connected to the stabilizer via the terminal blocks, the IEC-320-C13 sockets (3 pcs.) and the EURO F-type socket (1 pc.).
Indication
To monitor operation and the state of the mains, "Normal" and "Fault" indicator LEDs are installed on the front panel of the stabilizer.
The LCD display shows the main information on the input and output voltage values, the device's load level and its internal temperature, the power consumption of connected devices, and fault messages.
Protection
Electronic protection is provided by a built-in electronic bypass (allows the load to continue to be powered directly from the mains in the event of an overload), input and output filters (protect the load from high-frequency interference in the 100 kHz - 30 MHz range), and a built-in varistor (2 kV, 1/50 µs), which provides protection against surge overvoltages.
Monitoring facilities
The IS3500RT stabilizer has a built-in slot for installing one of the supported expansion boards, which contain the following interfaces:
RS-232;
USB or mini-USB;
dry contacts;
Ethernet (protocols: SNMP/Web/Modbus TCP).
Installing the expansion board allows configuration and local/remote monitoring of the stabilizer status via the web interface or Shtyl Device Manager – purpose-designed monitoring software.







