A set of three single-phase IS7000RT stabilisers in a rack with a total power consumption of up to 21 kVA/16.5 kW is a ready-made solution for protection against unstable 380 V mains voltage.
The stabiliser is manufactured in Russia and is perfectly adapted to the specific operating conditions of Russian power grids.
The quality of the device's operation is confirmed by a Customs Union conformity certificate (EAC). The manufacturer provides a 2-year warranty.
The device is equipped with a special stabilisation principle – double conversion of electricity, due to which an instantaneous response (0 ms) to any deviations in mains parameters is ensured with maximum accuracy (±2 %) over a wide input voltage range (90-310 V). It also has an output voltage with a perfect sine wave and the ability to provide uninterruptible power to connected devices in the event of a possible power outage (up to 200 ms).
Installation and connection
The IS7000RT stabilisers are installed in a metal two-frame rack with a height of 12U, intended for open and compact placement of 19-inch specialised equipment.
The devices can also be installed vertically on a flat horizontal surface using special stops. All fastening parts are included in the device's delivery package.
Each stabiliser is connected to a separate supply phase (in the absence of three-phase electrical appliances), which increases the system's resilience to power supply faults: failure of one phase will not affect the operation of the other two.
The IS7000RT models have a rotating control panel: when changing the position of the device (from vertical to horizontal or vice versa), its position can also be changed for more convenient use.
Terminal blocks located on the rear panel are used for connection to the mains and for powering the load.
Indication
To monitor the operation and state of the mains, signal LEDs "Normal" and "Fault" are installed on the front panel of the stabiliser.
The LCD display shows basic information about the input and output voltage values, the device load level and its internal temperature, the power consumption of connected devices, and alarm messages.
Cooling
Each stabiliser is force-cooled by 4 low-noise fans with adaptive rotation speed.
Protection
Each IS7000RT stabiliser has a built-in comprehensive protection system with automatic recovery.
Additional advantages of the IS7000RT include electronic and manual bypasses.
Monitoring facilities
The IS7000RT stabilizers have a built-in connector for installing one of the supported expansion boards, which provide the following interfaces:
RS-232;
USB or mini-USB;
"dry" contacts;
Ethernet (protocols: SNMP/Web /Modbus TCP).
Installing the expansion boards enables configuration and local/remote monitoring of the stabilizer's status via the Web interface or Shtyl Device Manager – specially developed monitoring software.
The boards are not included in the basic package and are purchased as an additional order.






