The IS3308RT inverter voltage stabiliser with three-phase input and single-phase output provides reliable protection against unstable 380 V mains voltage for single-phase loads in domestic, commercial or industrial applications with a total capacity of up to 8 kVA/7.2 kW.
The stabiliser is manufactured in Russia and is perfectly adapted to the specifics of Russian power grids.
The quality of the device is confirmed by a Customs Union certificate of conformity (EAC). The manufacturer provides a 2-year warranty.
The device uses a special stabilisation principle – double power conversion, which ensures an instantaneous response (0 ms) to any deviations in mains parameters with maximum accuracy (±2 %) over a wide input voltage range. It also provides an output voltage with a perfect sine wave and the ability to supply connected devices without interruption in the event of a possible power failure (up to 200 ms).
Cooling
The device is cooled by two low-noise fans with adaptive speed control. Their noise level at a distance of 1 m from the device is from 40 dBA to 61 dBA (depending on the rotation speed).
Installation and connection
The stabiliser is installed using the mounting parts supplied in the kit – vertically on support feet or horizontally using brackets in the 19-inch rails of telecommunications cabinets.
Mounting hardware for both installation options is included in the kit.
The IS3308RT model has a built-in control panel: when the position of the device is changed (from vertical to horizontal or vice versa), its position can also be changed for more convenient use.
Terminal blocks located on the rear panel are used for connection to the mains and for powering the load.
Indication
To monitor operation and the state of the mains, the front panel of the stabiliser has "Mains", "Fault", "Bypass", "Output" indicator LEDs.
The LCD display shows the main information on the input and output voltage values, the device load level and its internal temperature, the power consumption of connected devices, and alarm messages.
The display also allows settings: output voltage (in the range 220-240 V in 5 V steps), operating mode ("Stabilisation" or "ECO"), electronic bypass mode ("Auto", "Enable bypass", "Do not use"), start mode ("Auto start" or "By button"), the upper and lower limits of the permissible voltage range in ECO mode, and other parameters.
Protection
The IS3308RT stabilizer has a built-in comprehensive protection system with automatic recovery.
Monitoring facilities
The IS3308RT stabilizer has 2 built-in slots for expansion boards, which provide the following interfaces:
RS-232 and RS-485;
USB or mini-USB;
dry contacts;
Ethernet.
Installing an expansion board enables configuration and local/remote monitoring of the stabilizer's status via the Web interface or Shtyl Device Manager – specially developed monitoring software.
The boards are not included in the basic package and are purchased separately.










