Inverter voltage stabiliser IS3120RT with three-phase input and single-phase output - will provide reliable protection against unstable voltage in a 380V network for single-phase loads of domestic, commercial or industrial application with total capacity up to 20 kVA/16 kW. IS3120RT enables connection of a single-phase load to a three-phase network with even loading, and eliminates the possibility of network imbalance, as well as removing the need for constant inter-phase balancing.
The stabiliser is manufactured in Russia and is well adapted to the specifics of operation of Russian power grids.
The quality of the device's operation is confirmed by a Customs Union conformity certificate (EAC).The manufacturer provides a 2-year warranty.
The device is equipped with a special stabilisation principle – double power conversion, which ensures an instantaneous response (0 ms) to any deviations in mains parameters with maximum accuracy (±2 %) across a wide input voltage range (90-310 V). It also has an output voltage with a perfect sine wave and the ability to provide uninterruptible power to connected devices in the event of a possible power outage (up to 200 ms).
CoolingThe stabiliser uses an intelligent cooling system with four fans.Their noise level at a distance of 1 m from the device is from 42 dBA to 64 dBA (depending on rotation speed).
Installation and connectionThe stabiliser is installed using the mounting parts supplied - vertically on support feet or horizontally using brackets in the 19-inch rails of telecommunications cabinets.
Mounting fittings for installation in both orientations are included.
The IS3120RT model has a built-in control panel: when the device position is changed (from vertical to horizontal or vice versa), its position can also be changed for more convenient use.
Terminal blocks on the rear panel are used for connection to the mains and to power the load.
IndicationFor monitoring operation and the mains status, signal LEDs "Mains", "Alarm", "Bypass", "Output" are installed on the front panel of the stabiliser.
The LCD display shows basic information on the input and output voltage, the device load level and its internal temperature, the power consumption of connected devices, and alarm messages.
The display also allows settings: output voltage (in the range 220-240 V in 5 V steps), operating mode («Stabilisation» or «ECO»), electronic bypass mode («Auto», «Enable bypass», «Do not use»), start mode («Auto-start» or «By button»), the upper and lower limits of the permissible voltage range in «ECO» mode, and other parameters.
The IS3120RT stabiliser has a built-in comprehensive protection system with automatic recovery.
The device is equipped with built-in surge protection (2 kV varistor, 1/50 µs) and high-frequency filters (100 kHz – 30 MHz).
The electronic bypass provides automatic transfer of the load supply to the mains in the event of overload, stabiliser malfunctions, or when ECO mode is selected.
Monitoring tools: The IS3120RT stabiliser has 2 built-in connectors for expansion boards, which provide the following interfaces:
RS-232 and RS-485; USB or mini-USB;
dry contacts;
Ethernet.
Installing an expansion board allows configuration and local/remote monitoring of the stabiliser status via the Web interface or Shtyl Device Manager – specially developed monitoring software.
The boards are not included in the basic package and are purchased separately.










