Inverter voltage stabiliser IS3110RT with three-phase input and single-phase output - will provide reliable protection against unstable voltage in a 380 V network for single-phase loads in domestic, commercial or industrial applications with a total capacity of up to 10 kVA/8 kW.
IS3110RT enables connection of a single-phase load to a three-phase network with even loading, and eliminates the possibility of mains phase imbalance, as well as removing the need for constant inter-phase balancing.
The stabiliser is manufactured in Russia and is well adapted to the specific operating conditions of Russian power grids.
The operating quality of the device is confirmed by a Customs Union certificate of conformity (EAC). The manufacturer provides a 2-year warranty.
The device is equipped with a special stabilisation principle – double power conversion, owing to which an instantaneous response (0 ms) to any deviations in mains parameters is ensured with maximum accuracy (±2 %) over a wide input voltage range (90-310 V). It also has an output voltage with a perfect sine wave and the ability to provide uninterruptible power supply to connected devices in the event of a possible power outage (up to 200 ms).
Cooling
Cooling is performed by two low-noise fans. Their noise level at a distance of 1 m from the device ranges from 40 dBA to 61 dBA (depending on the operating speed).
Installation and connection
The stabiliser is installed using the mounting parts supplied in the kit - vertically on support feet or horizontally using brackets in the 19-inch rails of telecommunications cabinets.
Mounting brackets for both installation options are included in the kit.
The IS3110RT model has a built-in control panel: when the position of the device changes (from vertical to horizontal or vice versa), its position can also be changed for more convenient use.
Terminal blocks located on the rear panel are used for connection to the mains and for powering the load.
Indication
For monitoring the operation and status of the mains, signal LEDs "Mains", "Fault", "Bypass", "Output" are installed on the front panel of the stabiliser.
The LCD display shows basic information about the input and output voltage values, the device load level and its internal temperature, the power consumption of connected devices, and alarm messages.
In addition, the display offers the following settings: output voltage (in the 220–240 V range in 5 V steps), operating mode ("Stabilisation" or "ECO"), electronic bypass mode ("Auto", "Enable bypass", "Do not use"), start mode ("Autostart" or "By button"), the upper and lower limits of the permissible voltage range in "ECO" mode and other parameters.
Protection
The IS3110RT stabiliser incorporates a comprehensive protection system with automatic recovery.
Monitoring tools
The IS3110RT stabiliser has 2 built-in slots for expansion boards, which provide the following interfaces:
RS-232 and RS-485;
USB or mini-USB;
dry contacts;
Ethernet.
Installing an expansion board enables configuration and local/remote monitoring of the stabiliser status via the web interface or Shtyl Device Manager – purpose-developed monitoring software.
The boards are not included in the basic package and are purchased separately.







