Single-phase inverter voltage stabiliser IS10000 is manufactured in Russia and is perfectly suited for providing high-quality power supply and protection against surges and fluctuations in mains voltage for standalone equipment and groups of electrical appliances for domestic or industrial use with a total power consumption of up to 10 kVA/9 kW.
The device is adapted to the operating characteristics of Russian electrical networks.Quality of its operation is confirmed by the Customs Union certificate of conformity (EAC).
The IS10000 stabiliser is a latest-generation device with improved performance characteristics and a distinctive stabilisation method - double conversion of electricity, by means of which it continuously corrects the mains voltage over a wide range (90-310 V) and produces an output voltage with an accurate sine wave (± 2 %), and also, in the event of no power, supplies the load uninterruptedly for 200 ms.
The IS10000 is equipped with a convection and fan cooling system.The fans are switched on in turn and only when the internal temperature of the device reaches a critical level.
Installation and connectionThe stabiliser is installed inside residential and technical premises and is mounted on any flat vertical surface using self-tapping screws, which are inserted into special holes on the rear side of the enclosure.
Terminal blocks located on the enclosure are used for connection to the mains and for powering the load.
Indication
Operation of the stabiliser is monitored via LED indicators marked "Normal" and "Fault" and an LCD display showing the input and output voltage values, the load level bar, power, device temperature and alarm messages in the event of a device malfunction.
On the display, the output voltage value can be changed within the range of 220–230 V in 1 V steps.
ProtectionThe device is equipped with modern electronic emergency protection with automatic recovery in the event of internal overheating, overload, short circuit, excessively low or high mains voltage (less than 90 V or more than 310 V) and internal faults of the device.
The stabilizer has a built-in automatic and manual bypass and a varistor (2 kV, 1/50 μs). Protection against high-frequency interference is provided by mains filters.











