The single-phase inverter voltage stabiliser IS7000 is manufactured in Russia and is ideally suited to providing high-quality power supply and protection against surges and fluctuations in mains voltage for standalone equipment and groups of electrical appliances for domestic or industrial use with a total power consumption of up to 7000 VA/ 5500 W.
The device is adapted to the specifics of Russian power grids.The quality of its operation is confirmed by a Customs Union certificate of conformity (EAC).
The IS7000 voltage stabiliser is a latest-generation device with improved performance characteristics and a distinctive stabilisation method – double power conversion – by means of which it continuously corrects the mains voltage over a wide range (90-310 V) and produces an output voltage with a precise sine wave (± 2 %), and, in the event of power failure, also supplies the load uninterruptedly for 200 ms.
The IS7000 is equipped with a convection and fan cooling system.The fans are switched on in sequence and only when the internal temperature of the device reaches a critical level.
Installation and connection: the stabiliser is installed inside residential and technical premises and mounted on any flat vertical surface using a special bracket and stop that provides additional fixing. The fasteners are included.
Terminal blocks located on the enclosure are used for connection to the mains and for supplying the load.
Control panel: operation of the stabiliser is monitored via LED indicators marked "Normal" and "Fault" and an LCD display showing the input and output voltage values, load level scale, power, device temperature and fault messages in the event of a device malfunction.
On the display, the output voltage value can be changed within the range of 220–230 V in 1 V steps.
ProtectionThe device is equipped with modern electronic emergency protection with automatic recovery in the event of internal overheating, overload, short circuit, excessively low or high mains voltage (below 90 V or above 310 V) and internal faults of the device.
The stabiliser has a built-in automatic and manual bypass and a varistor (2 kV, 1/50 µs). Protection against high-frequency interference is provided by mains filters.







