The three-phase UPS ST33120 is used to ensure uninterrupted operation and centralised protection against voltage fluctuations in a 380 V network for critical loads with a total capacity of 120 kVA/108 kW, for example:
- small, medium and large data centres;
- communication systems and telecommunications centres;
- modular and virtualised data centres;
- IT infrastructure of offices and banks.
The UPS component base (power modules, bypass and monitoring module) is housed inside a robust monolithic cabinet with a door featuring a dust filter.
The ability to connect up to 6 ST33120 UPS units in parallel allows the output power of the uninterruptible power supply system to be increased in stages up to 720 kVA, and also allows redundancy technology to be used to build highly reliable configurations with constant operational readiness.
The ST33120 online UPS operates on the basis of double conversion technology, which provides:
- wide mains voltage stabilisation range (228-478 V) without switching to battery power;
- instant and seamless transfer of the load power to the battery when the mains voltage fails and back when it is restored;
- continuous supply of the load with sinusoidal voltage of high accuracy (±1.5%);
- maximum protection of the load from adverse effects of the mains;
- full independence of the output voltage characteristics from the mains condition.
Connection
The load power supply and mains connection are carried out via busbars.
Battery operation
Battery operation of the load is provided by external batteries. Modular battery racks and battery cabinets are provided for their installation. For correct selection of external batteries and accessories for their placement, please contact the specialists of the SHTYL Group plant.
The ST33120 UPS is also equipped with a built-in charger; its current is set in the range from 1 to 20% of the UPS capacity.
Control panel
Configuration and monitoring of the main operating parameters of the product are performed using the control panel. It includes an LCD display and LED indication.
The LCD display shows the input and output voltage, mains frequency, apparent and active load power, UPS load percentage of its rated power, the alarm log and other device parameters.
The LED indicators signal the status of the UPS itself and of its individual units: rectifier, batteries, bypass circuit, inverter and output.
Each UPS power module has its own control panel that allows monitoring of the module's operating parameters and status.
Protection
The ST33120 has a modern multi-level protection system against:
- overload and short circuit;
- internal overheating;
- high-frequency mains interference and impulse overvoltages;
- switching transients and non-linear distortion;
- "deep" battery discharge.
The UPS has two types of bypass built in:
- electronic – automatically switches the load power to the mains in the event of overload or UPS failure;
- manual – used when UPS maintenance or repair is required without interrupting the load power.
Monitoring tools
The UPS is equipped with USB, RS-232 and dry contact ports, allowing remote/local control and monitoring of the device.
An expansion card with an Ethernet interface (SNMP protocol) can additionally be connected to the device. Please note that this expansion card is not included in the standard scope of supply and must be purchased separately.
A web browser or the Shut Down Manager and Shtyl Device Manager programs are used for remote monitoring of the UPS operation.
- Advantages





