The three-phase UPS ST33080 is designed to ensure uninterrupted operation and centralised protection against mains voltage fluctuations of various three-phase power supply systems with a total capacity of 80 kVA / 72 kW, for example:
- data centres;
- telecommunications companies;
- shopping and entertainment centres.
The UPS component base (power modules, bypass and monitoring module) is installed inside a robust monolithic cabinet with a door featuring a dust filter.
The ability to connect up to 6 ST33080 UPS units in parallel allows the output power of the uninterruptible power supply system to be increased in stages up to 480 kVA, and also allows redundancy technology to be used to build highly reliable configurations with constant operational readiness.
The ST33080 is an online topology UPS operating on the basis of double conversion technology, which provides:
- wide mains voltage stabilisation range (228-478 V) without switching to battery power;
- instant and seamless transfer of the load power to the battery when the mains voltage fails and back when it is restored;
- continuous supply of the load with sinusoidal voltage of high accuracy (±1.5%);
- maximum protection of the load from adverse effects of the mains;
- full independence of the output voltage characteristics from the mains condition.
Connection
The mains and the load are connected to the UPS via busbars located on the rear of the device.
Battery operation
Battery operation of the load is provided by external batteries. Modular battery racks and battery cabinets are provided for their installation. For correct selection of external batteries and accessories for their placement, please contact the specialists of the SHTYL Group plant.
The ST33080 UPS is also equipped with a built-in charger; its current is set in the range from 1 to 20% of the UPS capacity.
Control panel
Configuration and monitoring of the main operating parameters of the product are performed using the control panel. It includes an LCD display and LED indication.
The LCD display shows the input and output voltage, mains frequency, apparent and active load power, UPS load percentage of its rated power, the alarm log and other device parameters.
The LED indicators signal the status of the UPS itself and of its individual units: rectifier, batteries, bypass circuit, inverter and output.
Each UPS power module has its own control panel that allows monitoring of the module's operating parameters and status.
Protection
The ST33080 is equipped with a modern multi-level protection system against:
- overload and short circuit;
- internal overheating;
- high-frequency mains interference and impulse overvoltages;
- switching transients and non-linear distortion;
- "deep" battery discharge.
The UPS has two types of bypass:
- electronic – automatically switches the load power to the mains in the event of overload or UPS failure;
- manual – used when UPS maintenance or repair is required without interrupting the load power.
Monitoring tools
The presence of USB, RS-232 and dry contact ports enables remote/local control and monitoring of the UPS.
An expansion card with an Ethernet interface (SNMP protocol) can additionally be connected to the device. Please note that this expansion card is not included in the standard scope of supply and must be purchased separately.
Device operation is tracked directly in a web browser or in Shut Down Manager and Shtyl Device Manager software.
- Advantages





