The ST33060 UPS is a professional system for providing high-quality power supply and uninterrupted operation of critical three-phase equipment for commercial and industrial use with a total capacity of 60 kVA / 54 kW, for example:
- computer rooms, server rooms, IT infrastructures;
- security systems;
- radio and television broadcasting facilities;
- telecommunications equipment.
The entire component base of the ST33060 UPS (power modules, bypass and monitoring module) is installed inside a robust monolithic cabinet with a door featuring a dust filter.
The ability to connect up to 6 ST33060 UPS units in parallel allows the output power of the uninterruptible power supply system to be increased in stages up to 360 kVA, and also allows redundancy technology to be used to build highly reliable configurations with constant operational readiness.
The ST33060 is an online topology UPS operating on the basis of double energy conversion technology, which provides:
- wide mains voltage stabilisation range (228-478 V) without switching to battery power;
- instant and seamless transfer of the load power to the battery when the mains voltage fails and back when it is restored;
- continuous supply of the load with sinusoidal voltage of high accuracy (±1.5%);
- maximum protection of the load from adverse effects of the mains;
- full independence of the output voltage characteristics from the mains condition.
Connection
Connection to the mains and to the load is made via busbars located on the rear panel of the device.
Battery operation
Battery operation of the load is provided by external batteries. Modular battery racks and battery cabinets are provided for their installation. For correct selection of external batteries and accessories for their placement, please contact the specialists of the SHTYL Group plant.
The ST33060 UPS is also equipped with a built-in charger; its current is set in the range from 1 to 20% of the UPS capacity.
Control panel
Configuration and monitoring of the main operating parameters of the product are performed using the control panel. It includes an LCD display and LED indication.
The LCD display shows the input and output voltage, mains frequency, apparent and active load power, UPS load percentage of its rated power, the alarm log and other device parameters.
The LED indicators signal the status of the UPS itself and of its individual units: rectifier, batteries, bypass circuit, inverter and output.
Each UPS power module has its own control panel that allows monitoring of the module's operating parameters and status.
Protection
The ST33060 uses a multi-level protection system against:
- overload and short circuit;
- internal overheating;
- high-frequency mains interference and impulse overvoltages;
- switching transients and non-linear distortion;
- "deep" battery discharge.
The UPS is equipped with two types of bypass:
- electronic – automatically switches the load power to the mains in the event of overload or UPS failure;
- manual – used when UPS maintenance or repair is required without interrupting the load power.
Monitoring tools
The UPS communication connector module allows remote monitoring and control of the device. The module houses the following interfaces: USB, RS-232 and dry contacts.
An Ethernet adapter (SNMP protocol) can additionally be connected to the UPS. Please note that it is not included in the standard scope of supply and must be purchased separately.
The device itself is monitored in a web browser or in the Shut Down Manager and Shtyl Device Manager software.
- Advantages





