The three-phase UPS ST33040 is the optimal solution for ensuring uninterrupted operation and protecting the power supply from mains voltage fluctuations of critical three-phase and single-phase equipment with a total capacity of up to 40 kVA / 36 kW, for example:
- telecommunications equipment and communication systems;
- IT equipment;
- of Hi-Tech audio equipment;
- television equipment;
- retail and entertainment equipment.
The ability to connect up to 6 ST33040 UPS units in parallel allows the output power of the uninterruptible power supply system to be increased in stages, as the number of consumers grows, up to 240 kVA, and makes it easier on the budget at the initial purchase stage.
The ST33040 is an online topology UPS with double conversion technology, thanks to which the device provides:
- operation over a wide mains voltage range (228-478 V) without switching to battery power;
- instant and seamless transfer of the load power to the battery when the mains voltage fails;
- continuous supply of the load with sinusoidal voltage of high accuracy (±1.5%);
- maximum protection of the load from adverse effects of the mains;
- full independence of the output voltage characteristics from the mains condition.
Installation and connection
The ST33040 is installed on any flat horizontal surface on swivel castors. The UPS power supply and load connection are made via terminal blocks located on the rear panel of the device.
Battery operation
A special connector for external batteries and a charger allow the load to operate autonomously for the required time. The charger current is set in the range from 1 to 20% of the UPS power. For correct selection of external batteries, please contact the specialists of the SHTYL Group plant.
Control panel
Configuration and monitoring of the main operating parameters of the product are performed using the control panel. It includes an LCD display, a current path mimic diagram, LED indicators and control buttons.
The device's LCD display shows the input and output voltage, its frequency, the apparent, active and reactive load power, UPS load percentage of its rated power, remaining battery runtime, the alarm log and other device parameters.
The LED indicators signal the status of the UPS itself and of its individual units: rectifier, batteries, bypass circuit, inverter, output.
Protection
The ST33040 is equipped with a multi-level protection system against:
- overload and short circuit;
- internal overheating;
- high-frequency mains interference and impulse overvoltages;
- switching transients and non-linear distortion;
- "deep" battery discharge.
The UPS has two types of bypass: electronic bypass – for uninterrupted automatic transfer of load power to the mains if the UPS fails or is overloaded; technical bypass – for servicing the UPS without interrupting the load power supply.
Monitoring tools
The ST33040 functionality provides remote monitoring and control of the device. For this purpose, the rear of the UPS has USB, RS-232 and RS-485 ports (Modbus RTU and Modbus ASCII protocols) and dry contacts.
An expansion card with an Ethernet interface (SNMP/HTTP/HTTPS/SSH protocols) can additionally be connected to the UPS. Please note that this expansion card is not included in the standard scope of supply and must be purchased separately.
After installing the board, the UPS operation is easily monitored in a web browser or using special software: Shut Down Manager or Shtyl Device Manager.
- Advantages







