The ST33030S UPS is designed to ensure uninterrupted operation and reliable protection against unstable voltage of critical three-phase and single-phase equipment with a total capacity of up to 30 kVA /27 kW, for example:
- telecommunications equipment and communication systems;
- IT equipment;
- of Hi-Tech audio equipment;
- television equipment;
- retail and entertainment equipment.
The ability to connect up to 6 ST33030S UPS units in parallel allows the output power of the uninterruptible power supply system to be increased in stages, as the number of consumers grows, up to 180 kVA, and makes it easier on the budget at the initial purchase stage.
The ST33030S is an online topology UPS. Thanks to double energy conversion technology, the device provides:
- operation over a wide mains voltage range (228-478 V) without switching to battery power;
- instant and seamless transfer of the load power to the battery when the mains voltage fails;
- continuous supply of the load with sinusoidal voltage of high accuracy (±1.5%);
- maximum protection of the load from adverse effects of the mains;
- full independence of the output voltage characteristics from the mains condition.
Installation and connection
The ST33030S has a floor-standing design and is intended for installation on any flat horizontal surface on swivel castors. The input mains and load are connected via terminal blocks located on the rear side of the UPS enclosure.
Battery operation
For autonomous power supply, the UPS has built-in batteries with a capacity of 9 Ah and a charger. They allow the device to run in autonomous mode for up to 6 min.
Control panel
Configuration and monitoring of the main operating parameters of the product are performed using the control panel. It includes an LCD display, a current path mimic diagram, LED indicators and control buttons.
The device's LCD display shows the input and output voltage, its frequency, the apparent, active and reactive load power, UPS load percentage of its rated power, remaining battery runtime, the alarm log and other device parameters.
The LED indicators signal the status of the UPS itself and of its individual units: rectifier, batteries, bypass circuit, inverter, output.
Protection
The ST33030S has a multi-level protection system against:
- overload and short circuit;
- internal overheating;
- high-frequency mains interference and impulse overvoltages;
- switching transients and non-linear distortion;
- "deep" battery discharge.
The electronic bypass provides automatic and uninterrupted transfer of the load power supply to the mains in the event of a UPS failure or overload. In addition, the device is equipped with a maintenance bypass for servicing the UPS without interrupting the load power supply.
Monitoring tools
The ST33030S is equipped with communication interfaces for remote monitoring and control. For this purpose, it has USB, RS-232, RS-485 ports (Modbus RTU and Modbus ASCII protocols) and dry contacts.
An expansion card with an Ethernet interface (SNMP/HTTP/HTTPS /SSH / Megatec protocols) can additionally be connected to the UPS. Please note that this expansion card is not included in the standard scope of supply and must be purchased separately.
After installing the board, the UPS operation is easily monitored in a web browser or using special software: Shut Down Manager or Shtyl Device Manager (SDM).
- Advantages







