The ST33030 UPS is used to ensure uninterrupted operation and effective protection against unstable voltage in a 380 V network of critical three-phase and single-phase equipment with a total capacity of up to 30 kVA /27 kW, for example:
- telecommunications equipment and communication systems;
- IT equipment;
- of Hi-Tech audio equipment;
- television equipment;
- retail and entertainment equipment.
The ability to connect up to 6 ST33030 UPS units in parallel allows the output power of the uninterruptible power supply system to be increased in stages, as the number of consumers grows, up to 180 kVA, and makes it easier on the budget at the initial purchase stage.
Model ST33030 belongs to the on-line class. The device uses double conversion technology, which provides:
- operation over a wide mains voltage range (228-478 V) without switching to battery power;
- instant and seamless transfer of the load power to the battery when the mains voltage fails;
- continuous supply of the load with sinusoidal voltage of high accuracy (±1.5%);
- maximum protection of the load from adverse effects of the mains;
- full independence of the output voltage characteristics from the mains condition.
Installation and connection
The ST33030 is intended for placement on any flat horizontal surface. The device is installed on swivel castors. Power supply and load connection are made via terminal blocks located on the rear side of the UPS enclosure.
Battery operation
To provide autonomous operation of the load, the UPS has a connector for external batteries and a charger. The charger current is set in the range from 1 to 20% of the UPS power. For correct selection of external batteries, please contact the specialists of the SHTYL Group plant.
Control panel
Configuration and monitoring of the main operating parameters of the product are performed using the control panel. It includes an LCD display, a current path mimic diagram, LED indicators and control buttons.
The device's LCD display shows the input and output voltage, its frequency, the apparent, active and reactive load power, UPS load percentage of its rated power, remaining battery runtime, the alarm log and other device parameters.
The LED indicators signal the status of the UPS itself and of its individual units: rectifier, batteries, bypass circuit, inverter, output.
Protection
The UPS has a modern multi-level protection system against:
- overload and short circuit;
- internal overheating;
- high-frequency mains interference and impulse overvoltages;
- switching transients and non-linear distortion;
- "deep" battery discharge.
The UPS model is equipped with a bypass function: the electronic bypass serves for uninterrupted automatic transfer of the load power to the mains in the event of UPS failure or overload; the technical bypass – for performing UPS servicing without interrupting the load power.
Monitoring tools
The ST33030 provides remote control. For this purpose, the rear side of the UPS has USB, RS-232, RS-485 ports (Modbus RTU and Modbus ASCII protocols) and «dry» contacts.
An expansion card with an Ethernet interface (SNMP/HTTP/HTTPS/SSH protocols) can additionally be connected to the UPS. Please note that this expansion card is not included in the standard scope of supply and must be purchased separately.
After installing the board, the UPS operation is easily monitored in a web browser or using special software: Shut Down Manager or Shtyl Device Manager.
- Advantages







