The SM030 (1x10) modular online UPS is the optimal solution for ensuring uninterrupted operation and reliable protection against voltage fluctuations in the 380 V mains for critical three-phase loads, for example:
- data centres, IT infrastructure of offices and enterprises;
- network and server equipment;
- electrical equipment of banks and shopping and entertainment centres.
SM030 (1x10) is a robust metal cabinet housing a 10 kVA /9 kW power module and other device components. The cabinet door has a dust filter.
Connecting additional power modules allows the output power of the power system to be increased to 30 VA / 27 kW, and parallel connection of up to 3 SM030 UPS units fully equipped with modules – to 90 kVA/ 81 kW.
SM030 (1x10) also supports redundancy technologies based on UPS modules or units to build highly reliable configurations.
The SM030 UPS (1x10) is built on the basis of double conversion technology, which provides:
- operation over a wide mains voltage range (228-478 V) without switching to battery power;
- instant and seamless transfer of the load power to the battery when the mains voltage fails and back when it is restored;
- continuous supply of the load with sinusoidal voltage of high accuracy (±1.5%);
- maximum protection of the load from adverse effects of the mains;
- full independence of the output voltage characteristics from the mains condition.
Hot-swap replacement of a failed power module is provided (without de-energising the UPS and the load). In this case, the load power will be distributed evenly among the operating redundant modules, if they were installed.
Connection
The electrical equipment and mains are connected to the UPS via busbars located on the rear panel of the device.
Battery operation
The SM030 UPS (1x10) does not contain built-in batteries, but is capable of providing long-term autonomous operation of the load by connecting external batteries. For the correct selection of external batteries and solutions for their installation, please contact the specialists of the SHTYL Group plant.
The SM030 UPS (1x10) is equipped with a built-in charger; its current is set in the range from 1 to 20% of the UPS power.
Control panel
A modern control panel is fitted on the UPS door, comprising an LCD display and LED indicators. They allow convenient monitoring of the device's operation and basic settings to be made.
The LCD display shows the input and output voltage, input frequency, apparent and active load power, UPS load percentage of its rated power, the alarm log and other device parameters.
The LED indicators signal the status of the UPS itself and of its individual units: rectifier, batteries, bypass circuit, inverter and output.
The power module installed inside the UPS has its own LCD display, which shows its operating parameters and allows its status to be monitored.
Protection
The SM030 (1x10) uses a multi-level protection system against:
- overload and short circuit;
- internal overheating;
- high-frequency mains interference and impulse overvoltages;
- switching transients and non-linear distortion;
- "deep" battery discharge.
The UPS is equipped with two types of bypass:
- electronic – allows automatic switching of the load power to the mains in the event of overload or UPS failure;
- manual – used when repair or servicing of the UPS is required without interruption to the operation of connected equipment.
Monitoring tools
The SM030 (1x10) model provides functionality for local/remote monitoring of the device operation.
The UPS communication connector module contains the following interfaces: dry contacts, USB and RS-232 ports, as well as an Ethernet interface supporting SNMP and SHTYL protocols.
The device is monitored using the Shut Down Manager or Shtyl Device Manager software.
The UPS also provides an EPO port for remote emergency shutdown.
- Advantages







