‎+7 (499) 500-24-60
Moscow, Udaltsova St., 81, bldg 2, office 6
Single-phase UPS

SHTYL SW300L online UPS (300 VA / 225 W)

  • Brand: Shtil
  • Product Code: SW300L
  • Availability: Pre-order
19 940 ₽

The online UPS SW300L is used to ensure uninterrupted operation and high-quality power supply for critical loads up to 300 VA/225 W, for example:

  • power-dependent heating boilers;
  • circulation pumps;
  • septic systems with low-power pumps;
  • smart home control units;
  • video surveillance systems;
  • critical low-power household appliances.

The SW300L uses an improved power factor corrector algorithm, thanks to which the model works excellently in conjunction with household generators.

Model SW300L operates on the basis of double conversion technology, which provides:

  • continuous voltage correction over an extended range (90-295 V) and with high accuracy (±2%) without switching to the batteries;
  • instant transfer of the load power to batteries when the power fails;
  • load power supply with a perfect sine wave regardless of the operating mode.

The model operates absolutely silently thanks to the convection (fanless) cooling system used in it.

Installation and connection

The SW300L is mounted on any flat vertical surface that can withstand a load of 4 kg. Installation is carried out using self-tapping screws. For convenience, the UPS delivery set includes a special template for marking the surface.

The device is connected to the input mains using a mains cable with a Euro plug. The load is connected to a EURO socket located on the side panel of the UPS.

Battery operation

The SW300L is equipped with a built-in charger with a charging current of 6 A, thanks to which it is possible to connect an external high-capacity battery (from 17 to 250 Ah). It can provide from 18 min to 9.5 h of autonomous load operation (at 100% UPS load). Depending on its capacity, the battery is placed in an external floor-standing rack BS-12-1W or BS-12-2W (Battery runtime table).

The UPS uses modern technologies to reduce charging time and extend battery life (intelligent charging and charge temperature compensation), as well as algorithms that allow:

  • disconnect the battery at 80-85% discharge (protection against deep discharge);
  • notify the user of battery wear;
  • predict the autonomy time at the current load (the value is displayed in the device web interface; a monitoring card is required for connection).

Control panel

The UPS control panel is equipped with function buttons that allow the device to be switched on/off, a cold start to be performed, the operating mode to be changed (online, bypass or ECO), and the battery to be tested (10-second forced supply of the load from the battery). The test is started by holding the Mode Change button for 3 seconds.

In addition, the UPS front panel has LED indicators showing the status of the device and the battery:

  • "Status" – device operating mode and occurrence of alarms;
  • "Bypass" – operation via bypass/ECO mode;
  • "Battery" – battery status.

Monitoring tools

  • RS-232 (Megatec protocol);
  • RS-485 (SHTYL protocol);
  • USB and mini-USB;
  • Ethernet (protocols Web/SNMP/NTP/Modbus TCP/SHTYL);
  • "dry" contacts.

The status of the SW300L UPS can be monitored in a web browser or in the Shtyl Device Manager (SDM) program. Editing the UPS parameters (start-up and operating mode, output voltage, rated output frequency when operating from the battery, bypass mode, on/off of the audible alarm, battery parameters, battery tests) is performed only via the "Settings" menu of the Shtyl Device Manager program when the computer is locally connected to the UPS via the USB interface or the RS-232 interface.

To remotely view the UPS status in a web browser, the device must be connected to the internet via an Ethernet connector. To set up such a connection, an IC-SNMP/Web or IC-SNMP/mini-USB interface expansion card is required.

Monitoring cards are not included in the standard scope of supply and are purchased separately.

Protection

The SW300L UPS has electronic protection against:

  • short circuit;
  • sustained output overload;
  • internal overheating.

Once the fault is eliminated, the device automatically restarts.

This model is also equipped with protection against:

  • impulse overvoltages (varistor – 2 kV ("case-wire"), 1 kV ("wire-wire"), response – 50 μs);
  • operating faults (in the event of a failure, the load is de-energised or seamlessly switched to the mains via the built-in bypass).

High-frequency filters protect the mains from interference in the 150 kHz - 30 MHz range and the load (from phase-to-neutral interference up to 2.5 kHz).

Model SW300L offers the optimal price/quality ratio compared with similar products from foreign vendors on the Russian power supply systems market.

  • Advantages

General specifications
Apparent power, kVA 0,3
Active power, kW 0,225
Form factor wall-mounted
Number of phases 1 to 1
Operating modes on-line, autonomous, bypass, ECO
Topology on-line (double conversion)
Country of manufacture Russia
Input characteristics
Generator compatibility yes
Input mains type single-phase three-wire (L, N, PE)
Input power factor 0,99
Limiting input voltage range, V 90-295
Maximum input current, A 1,9
Operating input voltage range, V 175-295 at 100% load, 155-295 at 75% load, 120-295 at 50% load
Power consumption in no-load mode, W 16
Rated input frequency, Hz 50
Rated input voltage, V 230
Soft start yes
Permissible input frequency range, Hz 45-65
Permissible deviation of the lower input voltage limit in ECO mode and for the electronic bypass, % -5, -10, -15, -20, -25 (default: -15)
Permissible deviation of the upper input voltage limit in ECO mode and for the electronic bypass, % +5, +10, +15, +20, +25 (default: +10)
Maximum bypass current, A 4,5
Output characteristics
Crest factor 3:1
Maximum output current, A 1,2
Output power factor 0,75
Output voltage type single-phase
Rated output frequency, Hz when operating from the mains – matches the mains frequency; when operating from the battery – set by the user: 50 (default)/ 60 (monitoring card required)
Transfer time to battery mode from on-line mode, ms 0
Output voltage total harmonic distortion, % <2.5 with linear load, <4 with non-linear load
Rated AC output voltage, V 230
Output voltage waveform pure sine wave
Efficiency in online mode, % 91
Efficiency in battery mode, % 82
Output voltage stabilisation accuracy, % ±2
Output frequency stabilisation accuracy (when operating from battery), % ±0,2
Overload capacity (when operating in on-line mode or from batteries) 101-105% – for 3 min, 105-130% – for 60 s, 130-150% – for 1 s, above 150% – for 0.2 s
Efficiency in bypass or ECO mode, % 99
Transfer time to battery mode from ECO mode, ms 7
Overload capacity (when operating via bypass or in ECO mode) 200% for 40 s
Protection
Output overload electronic protection with auto-restart
Overheating electronic protection with auto-restart
Short circuit electronic protection with auto-restart
Protection against UPS failure electronic emergency protection
Protection against deep battery discharge yes
Electronic automatic bypass yes
Surge protection varistor (2 kV (case-to-wire), 1 kV (wire-to-wire), response – 50 µs)
Mains protection against high-frequency interference 150 kHz - 30 MHz
Load protection against mains interference (between phase and neutral) up to 2.5 kHz
Control panel and interfaces
Audible alarm battery mode (every 4 s), low battery voltage (every 2 s), battery disconnected/fully discharged/needs replacement (every 0,5 s), overload and UPS fault (continuous)
Ethernet option (monitoring card required)
LED indication status, bypass, battery
RS-485 option (monitoring card required, data exchange only with SHTYL equipment)
Indication type LED indication
"Dry" contacts option (monitoring card required)
mini-USB option (monitoring card required)
RS-232 option (monitoring card required)
Function keys "On", "Off", "Mode change"
USB option (monitoring card required)
Temperature sensor option (monitoring card required)
Connection
Input mains power cable with Euro plug
Load (output sockets) EURO F-type with grounding (1 pc.)
Reliability and performance characteristics
Cooling type convection (fanless)
Degree of protection against dust and moisture IP20
Installation indoor
Operating altitude, m up to 3000 m above sea level
Relative humidity, % from 0 to 80 (non-condensing)
Service life, years 10
Warranty period, months 24
Operating temperature range, °C from +5 to +40
Storage temperature range, °C from -40 to +40
Mechanical characteristics
Housing colour grey
Weight, kg 4
Overall dimensions HxWxD (unpacked), mm 283x285x93
Overall dimensions HxWxD (packed), mm 330x330x140
Batteries (battery packs)
Battery availability external (option)
Hot-swap of built-in batteries no
Battery runtime (at 80% UPS load) Depends on the external battery capacity
Rated battery voltage, V 12
Battery type sealed, maintenance-free, lead-acid
Battery service life, years up to 7 (depending on operating conditions)
Battery management functionality deep discharge protection (LVD), charge temperature compensation, 10-second battery test
Cold start yes
Rated charge current of the built-in charger, A 6

Write to us

We will reply to info@levrus.ru shortly