‎+7 (499) 500-24-60
Moscow, Udaltsova St., 81, bldg 2, office 6
Single-phase UPS

SHTYL STR300SL-27 online UPS (300 VA)

  • Brand: Shtil
  • Product Code: STR300SL27
  • Availability: Pre-order
29 940 ₽

The STR300SL-27 online UPS in floor/rack design is used to provide autonomous operation and protection against voltage fluctuations for critical equipment with a total capacity of up to 300 VA/225 W, for example:

  • network equipment;
  • video surveillance systems;
  • emergency signalling;
  • smart home control units;
  • low-power household appliances.

The UPS has an advanced power factor corrector algorithm, which ensures efficient interaction with generator sets.

The STR300L-27 UPS uses double conversion technology, providing:

  • continuous voltage stabilisation in the 90-295 V range with high accuracy (±2%) without switching to the batteries;
  • instant and seamless switching of the load power to batteries when the mains power fails or goes outside the stabilisation range;
  • power supply to consumers with an ideal sine wave voltage in any operating mode.

The device is equipped with a low-noise fan with automatic speed control.

Installation and connection

The universal cabinet STR300L-27 allows installation in two ways:

  • floor-standing in a vertical position;
  • horizontally in a 19-inch rack (if the device is not placed on a shelf, it is recommended to additionally purchase a rack-mounting kit).

The device is connected via the following connectors:

  • for the load – three "computer" C13 sockets;
  • for the mains – cable with a Schuko plug, 1.5 m long.

Control panel

The STR300SL-27 control panel has function buttons and three LED indicators:

  • "Status" – device operating mode and occurrence of alarms;
  • "Bypass" – operation via bypass/ECO mode;
  • "Battery" – battery status.

The function buttons allow you to switch the UPS on/off, perform a cold start, change the operating mode (online, bypass or ECO), and test the batteries (10 seconds of forced battery-powered load supply). The test is started by holding the Mode Change button for 3 seconds.

Attention! Battery testing is recommended at least once every six months.

Battery operation

Battery operation of the load is provided by the built-in charger (current 3 A) and a battery block with three batteries with a total capacity of 27 Ah. At 100% load, the backup power supply to the connected electrical equipment will last 32 minutes (Battery runtime table).

Attention! The internal battery block is initially not connected to the UPS. This is done to prevent self-discharge of its battery. Before the first start-up of the device, the connector in the battery compartment must be connected. For more details, see the operation manual.

To increase the autonomous runtime to 1 h 20 min at 100% load, connection of the BMRT-12-27 battery module is provided (Battery Runtime Table).

The UPS uses modern technologies to reduce charging time and extend battery life (intelligent charging and charge temperature compensation), as well as algorithms that allow:

  • disconnect the battery at 80-85% discharge (protection against deep discharge);
  • notify the user of battery wear;
  • predict the autonomy time at the current load (the value is displayed in the device web interface; a monitoring card is required for connection).

Monitoring and configuration tools

  • RS-232 (Megatec protocol);
  • RS-485 (SHTYL protocol);
  • USB and mini-USB;
  • Ethernet (protocols Web/SNMP/NTP/Modbus TCP/SHTYL);
  • "dry" contacts;
  • temperature sensor.

The status of the STR300SL-27 UPS can be monitored in a web browser or in the Shtyl Device Manager (SDM) program. Editing the UPS parameters (start-up and operating mode, output voltage, rated output frequency when operating from the battery, bypass mode, on/off of the audible alarm, battery parameters, battery tests) is performed only via the "Settings" menu of the Shtyl Device Manager program when the computer is locally connected to the UPS via the USB interface or the RS-232 interface.

To remotely view the UPS status in a web browser, the device must be connected to the internet via an Ethernet connector. To set up such a connection, an IC-SNMP/Web or IC-SNMP/mini-USB interface expansion card is required.

Please note! The monitoring card is not included in the scope of supply and must be purchased separately.

Protection

The STR300SL-27 is equipped with several types of electronic protection:

  • against overload;
  • against short circuit;
  • against internal overheating.

Once the cause of the protection tripping is eliminated, the device automatically restarts.

In addition, the UPS has:

  • mains protection against high-frequency interference – 150 kHz - 30 MHz;
  • load protection against mains interference (between phase and neutral) – up to 2.5 kHz;
  • emergency protection against operational faults (when they occur, the UPS switches off the load or transfers its power supply to the mains without interruption via the bypass).

The STR300SL-27 online UPS from the SHTYL brand offers an excellent price/quality ratio compared with similar products from foreign vendors on the Russian power supply systems market.

  • Advantages

General specifications
Apparent power, kVA 0,3
Active power, kW 0,225
Form factor floor-standing/rack-mount
Number of phases 1 to 1
Operating modes on-line, autonomous, bypass, ECO
Topology on-line (double conversion)
Country of manufacture Russia
Input characteristics
Generator compatibility yes
Input mains type single-phase three-wire (L, N, PE)
Input power factor 0,99
Limiting input voltage range, V 90-295
Maximum input current, A 1,9
Operating input voltage range, V 175-295 at 100% load, 155-295 at 75% load, 120-295 at 50% load
Power consumption in no-load mode, W 16
Rated input frequency, Hz 50
Rated input voltage, V 230
Soft start yes
Permissible input frequency range, Hz 45-65
Permissible deviation of the lower input voltage limit in ECO mode and for the electronic bypass, % -5, -10, -15, -20, -25 (default: -15)
Permissible deviation of the upper input voltage limit in ECO mode and for the electronic bypass, % +5, +10, +15, +20, +25 (default: +10)
Maximum bypass current, A 4,5
Output characteristics
Crest factor 3:1
Maximum output current, A 1,2
Output power factor 0,75
Output voltage type single-phase
Rated output frequency, Hz when operating from the mains – matches the mains frequency; when operating from the battery – set by the user: 50 (default)/ 60 (monitoring card required)
Transfer time to battery mode from on-line mode, ms 0
Output voltage total harmonic distortion, % <2.5 with linear load, <4 with non-linear load
Rated AC output voltage, V 230
Output voltage waveform pure sine wave
Efficiency in online mode, % 91
Efficiency in battery mode, % 82
Output voltage stabilisation accuracy, % ±2
Output frequency stabilisation accuracy (when operating from battery), % ±0,2
Overload capacity (when operating in on-line mode or from batteries) 101-105% – for 3 min, 105-130% – for 60 s, 130-150% – for 1 s, above 150% – for 0.2 s (followed by switching to bypass)
Efficiency in bypass or ECO mode, % 99
Transfer time to battery mode from ECO mode, ms 7
Overload capacity (when operating via bypass or in ECO mode) 200% for 40 s
Protection
Output overload electronic protection with auto-restart
Overheating electronic protection with auto-restart
Short circuit electronic protection with auto-restart
Protection against UPS failure electronic emergency protection
Protection against deep battery discharge yes
Electronic automatic bypass yes
Surge protection varistor (2 kV (case-to-wire), 1 kV (wire-to-wire), response – 50 µs)
Mains protection against high-frequency interference 150 kHz - 30 MHz
Load protection against mains interference (between phase and neutral) up to 2.5 kHz
Control panel and interfaces
Audible alarm battery mode (every 4 s), low battery voltage (every 2 s), battery disconnected/fully discharged/needs replacement (every 0,5 s), overload and UPS fault (continuous)
Ethernet option (monitoring card required)
LED indication status, bypass, battery
RS-485 option (monitoring card required, data exchange only with SHTYL equipment)
Indication type LED indication
"Dry" contacts option (monitoring card required)
mini-USB option (monitoring card required)
RS-232 option (monitoring card required)
Function keys "On", "Off", "Mode change"
USB option (monitoring card required)
Temperature sensor option (monitoring card required)
Connection
Input mains IEC-320-C14
Load (output sockets) IEC-320-C13 (3 pcs.)
Priority disconnection of non-priority load no
Reliability and performance characteristics
Cooling type forced air cooling (fan)
Degree of protection against dust and moisture IP20
Installation indoor
Operating altitude, m up to 3000 m above sea level
Relative humidity, % from 0 to 80 (non-condensing)
Service life, years at least 10
Warranty period, months 24
Operating temperature range, °C from +5 to +40
Storage temperature range, °C from -40 to +40
Mechanical characteristics
Housing colour black
Weight, kg 16
Rack mounting height, U 2
Overall dimensions HxWxD (unpacked), mm 89x440x354 (rack, excluding brackets for horizontal mounting) 89x482x354 (rack, full dimensions) 467x207x354 (floor-standing)
Overall dimensions HxWxD (packed), mm 138x480x462
Batteries (battery packs)
Battery availability built-in
Hot-swap of built-in batteries yes
Battery runtime (at 80% UPS load) 45 min
Battery runtime at 100% (50%) UPS load, min 32 (80)
Internal battery capacity, Ah 27
Number of built-in 12 V batteries, pcs. 3
Rated battery voltage, V 12
Battery type sealed, maintenance-free, lead-acid
Battery service life, years up to 7 (depending on operating conditions)
Battery management functionality 10-second test, deep discharge protection, charge temperature compensation
Cold start yes
Rated charge current of the built-in charger, A 3
Built-in battery charge time, h no more than 8 (up to 90% capacity)

Write to us

We will reply to info@levrus.ru shortly