The kit consists of an ST1103L online UPS and two battery modules (BMT-96-09 and BMT-96-18). It provides backup power to a critical load for 30 minutes at 80% UPS load. It is used in offices, private houses or apartments for heating equipment, a computer, server or commercial equipment.
Thanks to the improved power factor corrector operating algorithm, the UPS functions in conjunction with diesel generator sets.
Cooled by low-noise fans with adaptive operation mode.
UPS with double conversion technology, thanks to which the device allows:
- stabilise the voltage over the range 90-295 V without switching to battery;
- instantly switch the load power to the battery when the mains fails;
- supply the load with high-accuracy voltage (±2%) with a pure sine wave.
Installation and connection
The UPS and the battery module are in a floor-standing design and are installed on any flat horizontal surface on rubber feet.
To power the load, the UPS rear panel provides C13 connectors (3 pcs), earthed Euro sockets (2 pcs) and C19 (1 pc). The C20 connector is used for connecting the input AC voltage.
Battery operation
The UPS has a built-in 2 A charger. Autonomous operation of the load is provided by battery modules. Equipment will run for 30 minutes at 80% UPS load. The battery runtime from built-in and external batteries at other UPS load levels is shown on the Battery Runtime tab.
The UPS employs modern technologies to reduce charging time and extend battery service life (intelligent charging and battery charge temperature compensation).
In addition, the model features special algorithms that allow:
- disconnect the battery at 80-85% discharge (protection against deep discharge);
- notify the user in advance of battery wear;
- accurately predict the autonomy time at the current load.
Control panel
The main operating parameters of the product are monitored and configured using the control panel. It includes an LCD display, four function keys and five LED indicators:
- "Status" – indicates the device operating mode;
- "Mains" – indicates mains status;
- "Bypass" – indicates a switch to bypass/ECO mode;
- "Inverter" – indicates inverter operation;
- "Battery" – shows the battery status.
Information on the LCD display:
- input and output voltage values;
- UPS load percentage;
- battery voltage values and their status;
- active and apparent load power;
- alarms with indication of their causes.
The control panel also allows three types of battery test to be performed:
- 10-second (the UPS supplies the load from the battery for 10 seconds);
- for a specified time (the UPS powers the load from the battery for a specified time);
- to full discharge (the UPS powers the load from the battery until it is fully discharged, measuring the residual capacity).
Protection
The UPS has modern electronic protection against overload, short circuit and internal overheating. After the cause of the electronic protection tripping is eliminated, the UPS restarts automatically.
The device is protected against high-frequency mains interference and impulse overvoltages, as well as by emergency protection against operating faults.
Monitoring tools
The UPS supports local/remote operation monitoring. For this purpose, the rear panel of the device provides two slots for installing expansion cards, which may contain the following interfaces:
- RS-232 (Megatec protocol);
- RS-485 (Modbus RTU/SHTYL protocols);
- USB and mini-USB;
- Ethernet (protocols Web/SNMP/NTP/Modbus TCP/SHTYL);
- "dry" contacts.
UPS operation with an installed interface expansion card is conveniently monitored via a web browser or the Shtyl Device Manager (SDM) software. The cards are not included in the standard configuration and are purchased separately.
- Advantages




