Compatibility
The BMRT-72-18 battery module is used together with single-phase STR series UPSs in floor/rack configuration with an output capacity of 2 and 3 kVA: STR1102SL, STR1102L, STR1102LD, STR1103SL, STR1103L, STR1103TL and STR1103TLD.
Autonomous operation
The BMRT-72-18 is a fully self-contained metal container with two pre-installed BP-72-09/RT battery units that provide the required UPS backup time for the STR series. Each unit houses six 12 V batteries of 9 Ah each. The nominal voltage of the battery group in the module is 72 V. The total battery capacity in the module is 18 Ah.
Up to 4 BMRT-72-18 battery modules can be connected to the UPS, allowing the backup power supply of electrical equipment to be scaled up to 1 hour 50 minutes at 80% UPS load (depending on the model's output power).
⇒ During long-term storage of the BMRT-72-18, the batteries must be charged every three months. If the storage temperature is above 30°C, then every two months.
Installation and connection
Can be installed in two operating positions: vertical and horizontal. For horizontal installation, it is mounted to 19-inch rails of telecommunications cabinets or racks using brackets. For vertical installation on the floor, a rack or a table, supports are used.
⇒ For rack or telecommunications cabinet installation, a rack mounting kit must be ordered separately, which will provide horizontal support for the module across the full depth of the structure.
The device is connected to the UPS or other battery modules via the TD50A Anderson connector, which is included.
Battery replacement
Front access to the slide-out battery blocks is provided. This allows the items to be removed or installed without dismantling the battery module. Battery blocks are replaced in hot-swap mode – without disconnecting the UPS and the load.
- Specifications







