The SHTYL Group of Companies offers power supply systems of model PS48-0080-3U ver.2 (4/1000) with a maximum output power of 4000 W, compliant with European quality standards. This high-tech device is designed to provide guaranteed, high-quality DC power supply to communication and telecommunications systems, industrial automation and any other electronic and electrical equipment with a 48 V supply voltage. A distinctive feature of the systems is operation over a wide input voltage range of 85-300 V.
The maximum output current of the model is 83.32 A. It must be taken into account that it must provide both load power and battery charging.
Design features
The power supply system is manufactured as a 19-inch subrack and is installed in cabinets and racks of the appropriate sizes. Device dimensions: 132.5x483x344 mm. The modular design of the product and the possibility of hot-swapping the power components (rectifiers) allow flexible systems to be designed that best meet customer requirements. Detailed information on the technical specifications of the various versions of the power supply system is given in the table below.
In addition to the power supplies (rectifiers), the products also include AC input switching equipment, load protection fuses, devices protecting the batteries against short circuits and deep discharges, an SHTYL PSC-200.03 controller for controlling the power system and organising monitoring, and a temperature sensor for measuring the temperature of the batteries. Please note that the batteries themselves are not included in the scope of supply of the product!
Operating principle
The SHTYL power supply system PS48-0080-3U ver.2 converts 220 V AC into 48 V DC. The products can be powered from one of two sources: a 220 V, 50 Hz industrial AC mains and a DC source (battery). AC power is supplied to the rectifier inputs. In normal mode, the power supply system converts the input AC voltage into DC, which is supplied to the inputs of the load circuit breakers and to the battery. The load is switched to battery power when there is no AC voltage at the rectifier inputs. The battery is connected in parallel with the rectifier output.
The power supply system is controlled and faults, errors and emergency situations are signalled by the PSC-200.03 controller, which also provides remote monitoring of the power system. For advanced monitoring of the battery condition, a battery supervisor module can optionally be installed in the product. One module provides cell-by-cell monitoring of one battery group or mid-point monitoring of several battery groups. The power supply systems allow up to four such modules to be connected.
- Advantages







