‎+7 (499) 500-24-60
Moscow, Udaltsova St., 81, bldg 2, office 6
Monitoring equipment

IC-RS232/Dry contacts monitoring card

  • Brand: Shtil
  • Product Code: IC-RS-232-DRY-CONTACTS
  • Availability: In stock
1 310 ₽

The IC-RS232/Dry Contacts interface expansion board is designed for local monitoring, control and configuration of SHTYL equipment:

  • InStab series inverter AC voltage stabilisers with a capacity of 6 - 20 kVA;
  • single-phase UPS of the ST, SR, SW, STR series with a capacity of 0.25-10 kVA.

The expansion board's front panel features the following connectors:

  • DB-9 RS-232 interface;
  • signalling – dry normally closed output contacts: 1 – general alarm signal; 2 – UPS/voltage stabiliser operating in bypass mode; 3 – UPS operating from batteries (not used for voltage stabilisers); 4 – common.

Status monitoring, parameter configuration and testing of the UPS/voltage stabiliser are performed via the RS-232 interface. The following protocols are supported:

  • Megatec – using third-party upper-level software compatible with this protocol;
  • proprietary SHTYL exchange protocol – using the specialised Shtyl Device Manager software.

The voltage at the output dry contacts must not exceed 26 V. The maximum current is 20 mA.

  • Specifications

General specifications
Country of manufacture Russia
Compatibility floor-standing/rack-mounted inverter voltage stabilisers, single-phase UPS
Accessory type monitoring cards
Number of phases of compatible UPS 1 to 1
Supported protocols Megatec/ SHTYL
Supported interfaces RS-232, dry contacts
Reliability and performance characteristics
Degree of protection against dust and moisture IP20
Installation into the internal slot of the voltage stabiliser or UPS
Relative humidity, % no more than 95
Warranty period, months 24
Operating temperature range, °C 5-40
Mechanical characteristics
Weight, kg 0,1
Overall dimensions HxWxD (unpacked), mm 40×68×65
Overall dimensions HxWxD (packed), mm 220×155×50
Signalling (dry contacts)
Maximum resistance relative to common, Ohm 35
Maximum load current, no more than, mA ±20
Permissible voltage, not more than, V ±26
Purpose of output dry contacts signalling of mains failure, bypass mode operation and deep battery discharge
Type and quantity 3 output

Write to us

We will reply to info@levrus.ru shortly