‎+7 (499) 500-24-60
Moscow, Udaltsova St., 81, bldg 2, office 6
Monitoring equipment

IC-Modbus/Dry contacts monitoring card

  • Brand: Shtil
  • Product Code: IC-MODBUS-DRY-CONTACTS
  • Availability: In stock
6 990 ₽

The SHTYL IC-Modbus/Dry Contacts interface board is designed to extend the functionality of other boards for monitoring the following equipment:

  • SHTYL InStab series AC voltage stabilisers with a capacity of 6-20 kVA;
  • single-phase SHTYL UPS of the ST, SR, STR series with a capacity of 1-10 kVA.

The IC-Modbus/Dry Contacts board adds the capabilities of an RS-485 interface supporting the MODBUS RTU protocol, as well as programmable dry output contacts and a dry input contact.

The expansion board's front panel features the following connectors:

  • signalling via dry contacts:
  • RS-485 – operation via the MODBUS RTU protocol to integrate UPS/voltage stabiliser status information transmitted to SCADA systems;
  • 4P4C – connector for connecting the SHTYL TS-1 sensor measuring the air temperature inside or near the UPS/voltage stabiliser (sensor not included in the scope of supply, available as an optional accessory).
  • 5 outputs – transmission of alarm signals and UPS/voltage stabiliser operating status;
  • 1 input – reception of input signals from external devices;

For connection via the RS-485 interface, two differential pair signals A and B are used, located on the external connector. The expansion board, in accordance with the MODBUS specification, is the master; its address on the MODBUS bus and communication parameters are configured in the specialised Shtyl Device Manager software. The purpose of the MODBUS protocol registers can be found in the Operating Manual for this product.

The IC-Modbus/Dry Contacts monitoring card is installed in the internal slot of SHTYL inverter voltage stabilisers and UPS and operates only together with the IC-SNMP/WEB or IC-SNMP/mini-USB card!

  • Specifications

General specifications
Country of manufacture Russia
Compatibility universal-design inverter voltage stabilisers from 6 kVA, single-phase UPS (operates only together with the IC-SNMP/WEB or IC-SNMP/mini-USB card)
Accessory type monitoring cards
Number of phases of compatible UPS 1 to 1
Supported protocols Modbus RTU/ SHTYL
Supported interfaces RS-485, dry contacts, 4P4C
Reliability and performance characteristics
Degree of protection against dust and moisture IP20
Installation into the internal slot of the voltage stabiliser or UPS
Relative humidity, % no more than 95
Warranty period, months 24
Operating temperature range, °C 5-40
Mechanical characteristics
Weight, kg 0,1
Overall dimensions HxWxD (unpacked), mm 40×68×65
Overall dimensions HxWxD (packed), mm 220×155×50
Signalling (dry contacts)
Output connector type pluggable terminal block, wire cross-section 0.5-1.5 mm², (15EDGR-2.5-08P)
Maximum resistance relative to common, Ohm 35
Maximum load current, no more than, mA ±20
Permissible voltage, not more than, V ±26
Purpose of input dry contacts determined during configuration
Purpose of output dry contacts determined during configuration
Type and quantity 5 output and 1 input
RS-485
Permissible voltage of A and B contacts, within, V from -13 to +16.5
Термоyesтчик
Temperature sensor output connector type 4P4C

Write to us

We will reply to info@levrus.ru shortly